@jseivert wrote:
I've recently discovered the control panel and think I may be doing something not quite right.
I have set up 2 equipment profiles close to the same and saved them as -attended and -unattended. The only difference between them is that the auto meridian flip is off and camera warmup is off for the attended, and those are on for unattended.If I have started a run with attended and decide to go in, I use the "apply profile to sequence" and select the unattended.
So now the question:
Will changes in the control panel override the settings in the equipment profile being used for the current sequence? So I wouldn't have to apply a new profile, just make the desired change in the control panel.Thanks!!!
Jeff
Posts: 1
Participants: 1