@PeterF wrote:
Up until now mosaic and plate solving has work perfectly but last night after running a two panel mosaic on NGC7822 SGpro moved the mount to target correctly and took an image. After plate solving the Scope ran out of control into the mount. Fortunately I was in the observatory at the time as I was also piggybacking. Normally I set the camera to cool and operate remotely. I tried to run this this sequence three times with the same result. I had to switch the mount off at the supply to prevent damage. Aborting the sequence had no effect. I checked the mount and it seemed to be working perfectly so I run an earlier created sequence which worked fine. It seems this particular event is the problem. The event was created with the same equipment profile as usual. I have recently installed the latest version of SGPro and this sequence was created with it. I will delete this sequence and recreate in the hope it will work correctly and test when clear skies allow. Has anyone any idea of what could have gone wrong or have experienced the same problem. I have an Ioptron CEM60 EC mount.
Posts: 3
Participants: 2