Run Away during Plate Solve / Centering

@bwallis wrote:

Tonight I started a sequence .... the telescope went off to point to the target and the plate solve
routine started.... it took one frame.... centering was off by a few hundred pixels.... and then when it
went to tweak the position the scope just took off !!! slewing dozens of degrees before I could hit STOP

I PARKED the scope and restarted the sequence.... and everything just worked fine... as usual

I've never seen any behavior like this before ... it sure made me a bit nervous about just letting
sequences run unattended ....

any ideas or suggestions ???

Posts: 3

Participants: 2

Read full topic