@CCDMan wrote:
This is RE 2.6.0.24. I do not need any of the present features in 3.X so have not upgraded yet.
This is pretty annoying and (maybe) could lead to problems. My friend and I are operating a dual scope system at a remote site. That means we have both two user profiles and multiple equipment profiles.
I have found that if I load a saved sequence, all is fine until I change the sequence. (note that the equipment setup has not been touched). Once I make a change to the sequence, suddenly the text at the top says "no equipment profile". OK, so then I have to apply the correct "profile to sequence" but when I do that it dumps the user profile so I also have to re-select that.
Rather annoying. Is this normal and what effect could it have? I am concerned that it might apply the wrong equipment and result in trouble.
Posts: 3
Participants: 2