@BirdrockImaging wrote:
Hello all,
I have been new to SGP and have been playing around with its cool tools.
I have been struggling with the “center on” tool after a meridian flip. Before the flip it takes the image, does the flip, then attempts to move back to the original location.
I have it set for within 50 pixels which it usually accomplishes within 2 recenters. However, after the meridian flip it gets “caught” in a location and will continually plate solve, note that it is off, not move, then take a picture, plate solve, not its not in the right place, etc. Until it eventually fails without moving once (I have it set to 6 recenters before failing).
At that point, I hit “center on again” it does another slew and then works perfectly and is usually within 10 pixels.
The rub is that it makes automation a lot harder since I would have to be at the mount for the meridian flip recenter.
Thanks for any help you can provide.
Posts: 3
Participants: 2