@midnightlightning wrote:
Hi,
Can anyone point me in the right direction to fix this?
I am using plate solver 2 and the Slew/Center buttons that are accessed from the Target Settings work fine - centering usually takes two attempts to get within a few pixels.
The problem comes when I then right click a Take One image to move the centre for framing purposes. When I do this the plate solving goes into a spiral search which I usually cancel after 5 or 10 minutes. This feature used to work and I’m not aware of any settings having been changed.
Interestingly, if I right click the image and “Plate Solve” (I think I used blind solve but am not 100% sure), it quickly returned a high confidence of the correct location and allowed me to save the coordinates.
Any thoughts welcome, I find this feature really useful when it works.
Posts: 3
Participants: 2