@MickG wrote:
I have a QHY168C. In the EZCP Online Users Manual under the section Advanced Camera Settings/ Tec protection, states the following “If you are using the battery, sometimes the input voltage will be up to 13.8v. The output voltage at 100% power is harmful for the TEC and reduce the life of TEC”.
I am using Sequence Generator Pro software for camera control. I have the following options in the Equipment Profile Manager for the camera:
Cool down to XX C in XX Min.
Warm up to XX C in XX Min.
I can check any of the following:
Cool down on camera connect
Cool down on sequence start
Warm up on sequence complete
What are your recommendations for these settings to prevent damage to the TEC in the camera.
Thanks
Posts: 2
Participants: 2
