@MarkW wrote:
HI Folks first of all I'm new to SGPro and I'm wanting to purchase this software but I've been trying to sort out a few problems first. I was having trouble plate solving but I think that's sorted but now I'm having problems with the images taken using SGpro.
I'm using a OSC QHY 10 and Astroart 6 to process them. However I've found for some strange reason I can't 'flat correct the images, I'm not sure if they are Bias and dark corrected either. I've gone through help on astroart forum but with no luck. Also I have been using Atroart for some years with no problem until now.
Anyway, I've looked at the Fits Header information on the images and the all say at the very top line "File does not conform to fits standard".......So I'm wondering if this is the cause of the problem and if so How do I correct it
Below are images of the fits header and I've highlighted in blue also the is an image that is supposed to be aligned stacked, bias, flat and dark corrected. Which you can plainly see has not been
Thanks for your help
Posts: 5
Participants: 3