@FrancescoPelizzo wrote:
Hi,
I'm facing a problem with the focuser setup in SGP 2.6.11 beta. I own a sharp sky pro and I run it in reverse as I mounted it on the micrometric wheel, opposite side of the main wheel. No issues with the previous version of SGP.
Now I set focuser parameters up (beta version) the same as I set them into the previous (non beta) release. Same parameters, both in SGP 2.6.11 and into the setup screen of the focuser as they were in SGP 2.5.17.
The problem is I can't set the zero position to zero. I set it to zero entering zero into the focuser setup screen as I was used to do, but SGP (beta) reads position 250000, not zero. 250000 is the maximum position achievable by the focuser when the tube is all out. Tried to unflag the reverse mode both here and there also in cross combination. No solution. zero is never zero but 250000. Help needed. Thanks.
Posts: 4
Participants: 3