Clik here to view.
Manual Focusing, HFR star button, large sensor, not accurate
@entilza wrote: Hello SGP Team and Ken welcome back! I just wanted to bring up some issues I've experienced since the new HFR changes. I have seen inaccurate HFR representations. I am not sure if this...
View ArticleSequence Generator Pro 2.5.2.3 Beta is Released for Testing
@Ken wrote: Hi folks, SGPro 2.5.2.3 is a beta release. While we love that many of our users are eager to help us test, make sure you are a fairly knowledgeable SGPro user before hopping onto the beta...
View ArticleSyncless centering successful! 2.5.2.3
@cmassa wrote: On my first try with syncless centering, SGP put my target within my set point of 20 pixels in 2 iterations. I'm imaging with a Paramount MX+. I haven't yet tried the newest version of...
View ArticleClik here to view.
Unable to start new beta 2.5.2.3
@BarryWilson wrote: I'm quite perplexed I installed the new beta this afternoon and clear skies forecast tonight. Installation all seemed fine. I opened the new beta once - all ok. Sent pc to sleep....
View ArticleClik here to view.
Add exclude center to autofocus (in same pane as "crop auto focus frame")
@Jay wrote: Add "exclude center" to autofucus. This, along with "crop auto focus frame" should reduce the focus effects on the edge of field. i.e. if focus is maxed in the very center, the edges will...
View ArticleExtending PHD2 guiding calibration / start up time
@buzz wrote: Hi - not so much as a feature request... I only need to guide every 5 seconds and the calibration routine in PHD2 and the initial settling time takes me into recovery mode at sequence...
View ArticleHelp getting SGP to slave/sync with a Foster Systems AstroMC dome
@dnube wrote: Looking for help - first time trying to get SGP to control a Foster Systems AstroMC dome. I can connect to the dome and managed to get it to (eventually) open the shutter - although...
View ArticleTrying to Understand the Camera Cooling part of this Software
@astronomynut wrote: I am new to SGP, and to cooled cameras. I have looked at the instructions, but apparently I am not knowledgeable enough to understand a lot of it. What I would like to know is...
View ArticleThe API logging... it burns us (2.5.2.3)
@pfile wrote: maybe because i'm using the SGP API guider, my logfile is enormous... 1.2GB after just 2 hours of operation. i think i'm going to have to go back to 2.5.2.1 or else my boot disk is going...
View ArticleStrange slew failure with SGP / TSX
@buzz wrote: I'll start off by saying I am not entirely sure where the problem lies. It may well be a combination of events. I have seen a few instances where SGP issued a slew command through ASCOM...
View Article2.5.2.3 works
@mads0100 wrote: It ran all last night without any issues. Posts: 3 Participants: 2 Read full topic
View ArticleThank you!
@Ladyhawke wrote: I've had all kinds of issues with my sequences but I'm so happy to say that last night, for the first time everything ran perfectly. I woke up refreshed (even though I kept an eye on...
View ArticleClik here to view.
Warning about autofocus
@libraryman2 wrote: i know this has been queried before, but just for clarification..im using the latest beta and i guess i expected it to be resolved, i know this doesn't happen in the earlier...
View ArticleSequence Generator Pro 2.5.2.4 Beta is Released for Testing
@Ken wrote: Hi folks, SGPro 2.5.2.4 is a beta release. While we love that many of our users are eager to help us test, make sure you are a fairly knowledgeable SGPro user before hopping onto the beta...
View ArticleClik here to view.
NGC7380 - Wizard Nebula in Hubble Palette Narrowband
@CarlightExpress wrote: NGC7380 - Wizard NebulaImage Details:22x 600S - 7nm HA19x 600S - 7nm OIII19x 600S - 7nm SII25 Darks and 25 Flat frames for each filterEquipment Used:Imaging Scope: Sky-Watcher...
View ArticleMosiac rotation angle issue
@aldo56 wrote: Last evening was trying to do a mosiac and all went well setting it up until it came time to solve and start. Used an image from Astrobin for the Aurgina region and kept getting a...
View ArticleSX USB Filter wheel + OAG
@GeneralT001 wrote: Hi, I installed this Starlightxpress FW but don't see it as an option in the drop down menu for the Filter Wheel. So how do I connect it or can I? Posts: 2 Participants: 1 Read...
View ArticleCan't run an "Event"
@GeneralT001 wrote: Only started tonight. In the show sequencer panel I set it to take 1 light frame of 30 sec. When I hit the "resume sequence" button it pops up the "sequence complete" dialog and...
View ArticlePlate solve from "home"
@bcstein12 wrote: When I start the night in the "home" position pointing to Polaris SGP fails to plate solve the initial position when the sequence starts to slew to a target. If I take a quick pic...
View ArticleTemperature compensate tolerance
@Kurious_George wrote: While playing with temperature compensate (and recommending "Autofocus with feedback" in this section) I noticed a correction is made for even a difference of a few tenths of a...
View Article